![]() ![]() In my case when the cartridge door was closing it looked like it was clamping down the tape between the head and the motorised rubber roller. Regarding ribbon not moving during printing on a Dymo LetraTag LT-100T with a variety of 12mm Dymo LetraTag label cartiges. I then cut off all but a quarter inch of the white tape, reinstalled the cartridge, and now have a working Dymo. The ribbon spool hole is located about 1/2 inch above and to the right of the āOā in the work DYMO. ![]() You can prevent the black tape from moving by using something that fits in the hole, like a pencil eraser, to keep the ribbon spool from moving. I managed to grab this small length of white tape and pull it out about 2 inches while preventing the black printer ribbon from moving at all. There was already about 1/4 inch white tape sticking out from the point where the black printer ribbon heads back into the cartridge. This point is about 1/2 inch below the letter āDā in the brand name DYMO on the cartridge. I removed the cartridge, got out my magnifying glass, and, looking at the side of the cartridge you see when it is installed in the DYMO, found the spot at which the white tape is supposed to separate from the printer cartridge ribbon. Had same problem with first tape cartridge I installed, which is the same one that came with my Dymo model 160. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |